Cost To Install New Ceiling Fan – Most people spend about $550 to install a new ceiling fan, and the average cost range for the project is between $150 and $2,000.
For a typical installation, the fan usually requires one to three hours of work, which usually costs between $100 and $600. A more complex installation or adding new wiring will likely increase the cost.
Cost To Install New Ceiling Fan
Most people think of a ceiling fan as a means of cooling a room without using an expensive air conditioner. However, you can also use it to redistribute warm air. The heat rises and stays there.
How Much Does It Cost To Install Ceiling Fans
During the cold winter months, the fan should run counter-clockwise or clockwise at low speed. This simple flick of a switch will gently redistribute the warm air trapped in the ceiling. The hot air is then pushed up the walls, down and back into the room.
How many square meters of space you are trying to cover with a ceiling fan will affect the size of the blades needed and therefore the size of the fan motor and its cost.
29-36 inch fan blades are suitable for rooms less than 75 square meters. ft. and cost between $50 and $150.
Fan blades of 36-44 inches will be acceptable for rooms 76-144 square feet. ft. and cost between $60 and $400.
Cost To Repair A Ceiling Fan
The extreme length of the blade can deform or bend down over time. They also have a commercial look that is off-putting to some homeowners. Therefore, using two or more ceiling fans is an alternative if you have a very large room to cool.
These are the fans most often found in homes with four or five blades and a light. You can buy one for $50 to $1,000 and install it using your existing fixture wiring for another $100 to $200.
Keep in mind that if you don’t have wiring, this can add up to $1,000 to the project.
A low-profile or mounted fan is best for ceilings under eight feet. These fans typically cost between $80 and $550.
How Much Does It Cost To Install A Ceiling Fan? A Comprehensive Guide
Remember that even low-profile fans require some space to operate safely. Make sure you have clearance when installing.
Propeller fans are suspended from the ceiling by a rod and are used in rooms with ceiling heights of 9 feet or higher and cost $150 to $1,000.
Propeller fans can be installed on vaulted ceilings or at an angle, as well as straight down. Remember that the higher they are placed and the more difficult the installation, the higher the labor costs.
The installer hangs the directional fan from the exhaust rod to point in the direction the owner wants more airflow. This can be a good choice for large rooms or rooms far from windows or other air sources.
Ceiling Fan Direction: Why Rotation Matters
A rotary ceiling fan has two fans suspended on a pole with a blade between them that rotate and rotate to create a greater airflow. The price of this unique design ranges from $300 to $3,000.
There are actually two classifications for indoor and outdoor fans: humidity rated and humidity rated. The humidity rated fan is an ideal fan for outdoor use as it has waterproof wiring and motor housing.
A moisture-proof fan, on the other hand, is resistant to high humidity and is usable in a closed terrace or garden pavilion, but not where rain or snow will reach it. These fans can cost more, starting at $300 to $3,000 each.
Experts recommend not hanging the ceiling lower than seven meters from the floor. But as a homeowner, you know what your requirements are.
What Is Tongue And Groove Ceiling And How Much Does It Cost?
Hanging a ceiling fan above the dining table is probably no problem, but be careful when changing the tablecloth.
A flat or low profile fan should be used in rooms with low ceilings. Use rods to hang ceiling fans in rooms with ceilings higher than nine feet.
Although the recommendation is to add six inches of rod for every foot over nine feet, this is at the homeowner’s discretion.
Many people think a long shaft looks unruly, but you may want the fan to be low enough to handle. Although duster extension rods are available, very tall fans can be difficult to clean easily, and dust that settles on the fan can quickly cover a room when the fan is on.
Harbor Breeze Centreville 52 In Brushed Nickel Indoor Flush Mount Ceiling Fan With Light (5 Blade) In The Ceiling Fans Department At Lowes.com
If you replace the ceiling fan with an equivalent in power and weight, your costs will be lower than if you install a new one or in a place where the wiring has not been done before. However, if the new fan weighs significantly more or the current cord or power switch is inadequate, you may need a new fan support bracket, a separate power switch, or perhaps even a new electrical panel, which can add to the cost.
As a general rule, it is recommended to have a professional licensed electrician install a new fan. We recommend getting at least three estimates on the project so you can choose the right electrician for your project. Try our electrician to find a professional in your area.
All pricing information on this page is based on industry average costs and may vary based on project-specific materials, labor rates and requirements. Reviewed by Salvatore Cutrona, Angi Board Member and Founder of Cutrona Electric, LLC in Sherman, CT Author.
Ceiling fan installation costs $249 on average and can usually range from $144 to $354. Hard-to-reach or complicated installations can reach $600. The job costs between $50 and $250. Residential fans range from $50 to $1,400, commercial fans from $3,500 and up.
Answers To Your Ceiling Fan Questions
Many factors affect the cost of installing a ceiling fan. Labor costs are probably the biggest expense for many homeowners who hire a local ceiling fan installer, but there are other aspects to consider when budgeting for this project, such as fan materials, any attached lighting, and whether the fan has a switch or remote control.
Labor is $50 to $200 off cost. A handyman costs between $25 and $50 an hour, while a licensed electrician costs between $50 and $100 an hour. The fee varies according to how difficult the ceiling fan is to install. Labor and materials (not including the cost of the fan) vary depending on the complexity of the installation:
What your ceiling fan is made of can affect the price. For example, a wooden ceiling fan costs on average between $100 and $400, while a stainless steel fan costs between $200 and $800. Other common materials for ceiling fans include plastic, wicker, and metals such as cast iron or aluminum.
A ceiling fan with light costs an average of $100 to $300 to install. With new wiring to separate the blades from the light on the various switches, you could end up paying $500 or more. When replacing a light fixture with a light/fan combo, you’ll often want to use existing wiring and agree to use a pull chain on the unit to start the blades or a remote if the unit comes with one. Installing a light switch is also around $100-$200.
The 8 Best Ceiling Fans Of 2024, Tested By Real People
Ceiling fan switch kits are relatively inexpensive and are available at most home improvement retailers. The type of switch makes little difference in cost. For example, a simple pull chain can be purchased for as little as $6, while a wall switch with a disc can cost up to $50.
Due to the saturation of the market with remote control products, ceiling fans with remote control usually do not cost much more than standard fans. You can pay anywhere from $150 to $300. But if you already have a ceiling fan that you like and want to add a remote control, you can buy an all-in-one ceiling fan remote control kit for about $15 to $30.
Cost factors include how much wiring is needed and whether you are installing multiple fans at once. You should also consider the type of ceiling fan you need based on your home’s style and energy efficiency goals.
To install a ceiling fan without existing wiring, a professional must cut holes in the walls, drill the holes, run the wires, install the boxes and make the final connection in the junction box. It costs between $350 and $2,000. More complex non-schematic jobs can add another $1,000 to $2,000.
Ceiling Fan Beams
Installing a ceiling fan with existing wiring costs an average of $100 to $300 for a basic installation, although some units cost as much as $1,400 for designer levels of comfort and style. To do this, a professional installs the unit on the existing light box. Then they place a support in the ceiling, if the box is not designed to bear the weight of the entire unit. Although cheaper, you don’t want the light and fan on separate switches. To power the switch, run another line and add a large box and switch.
Another option is to purchase a remote control fan to control the light and fan separately without running additional wires. Most cost between $150 and $300 without installation.
Installing two ceiling fans costs an average of $200 to $600, but can be steep
Cost for electrician to install ceiling fan, how to install a new ceiling fan, handyman cost to install ceiling fan, easy to install ceiling fan, electrician to install ceiling fan, average cost to install ceiling fan, to install a ceiling fan, handyman to install ceiling fan, cost to install ceiling fan, labor cost to install ceiling fan, cost to install outdoor ceiling fan, lowes cost to install ceiling fan